Clover B14A Hot and Cold Bottled Water Dispenser User Manual

1. Увод

The Clover B14A Hot and Cold Bottled Water Dispenser provides convenient access to refreshing chilled drinking water and piping hot water. Designed for home or office use, this dispenser features hygienic stainless steel tanks and an efficient cooling and heating system. Please read this manual thoroughly before operation to ensure safe and optimal performance.

2. Безбедносне информације

• електрична безбедност: This appliance operates on 110-120 volts, 50-60 Hz. Ensure the power outlet is properly grounded. Do not use with damaged cords or plugs.
• Безбедност топле воде: The hot water temperature reaches approximately 185°F (85°C). Exercise extreme caution when dispensing hot water to prevent burns. A safety switch is provided for the hot water dispenser.
• Безбедност деце: Always engage the hot water safety switch when children are present to prevent accidental dispensing of hot water.
• Пласман: Place the dispenser on a flat, stable surface away from direct sunlight, heat sources, and areas with high humidity. Ensure adequate ventilation around the unit.
• Боца за воду: Use only standard 5-gallon (18.9-liter) water bottles.
• Одржавање: Искључите уређај из струје пре чишћења или било каквог одржавања.

3. Подешавање

1. Распакивање: Пажљиво извадите дозатор из паковања. Проверите да ли има оштећења.
2. Пласман: Position the dispenser on a level, sturdy surface. Allow at least 4 inches (10 cm) of clearance from walls for proper ventilation.
3. Инсталирајте посуду за капање: Insert the concealed, lift-out drip tray into its designated slot below the spigots.
4. Прво чишћење: Пре прве употребе, очистите спољашњост меком крпомamp тканина.
5. Инсталирајте боцу за воду: Remove the protective seal from a new 5-gallon water bottle. Lift the bottle and quickly invert it, placing it firmly onto the bottle support on top of the dispenser. Ensure the bottle is seated correctly to prevent leaks.
6. Систем за испирање: Before plugging in, dispense at least 1 liter (approximately 4 cups) of water from both the hot and cold spigots to ensure the tanks are filled and to flush any air from the system.
7. Прикључак: Plug the power cord into a grounded 110-120V electrical outlet.

Слика 1: Пуно view of the Clover B14A water dispenser with a 5-gallon bottle.

4. Упутство за употребу

1. Укључено: Once plugged in, the dispenser will begin cooling and heating the water. Allow approximately 15-30 minutes for the water to reach desired temperatures.
2. Испуштање хладне воде: Place your cup under the cold water spigot (typically blue). Push the lever to dispense cold water. Release the lever to stop.
3. Испуштање топле воде: Place your cup under the hot water spigot (typically red). To dispense hot water, first push the safety switch (often a red button or lever) and then push the main lever. Release both to stop.
4. Прекидач за топлу воду: The hot water function can be turned on or off using the switch located on the back of the unit. Turning it off will prevent the water from heating, saving energy and acting as an additional safety measure.
5. Adjusting Cold Water Temperature: The cold water temperature can be adjusted via a thermostat control, usually located on the back of the unit. It allows for a range of 35.6°F to 53.6°F (2°C to 12°C).

Figure 2: Detail of the hot (red) and cold (blue) water spigots with the hot water safety switch.

5. Одржавање

• Чишћење посуде за капање: The drip tray is removable for easy cleaning. Periodically empty and wash the tray with mild soap and water.
• Спољно чишћење: Обришите спољашње површине меком, дamp тканина. Немојте користити абразивна средства за чишћење или раствараче.
• Уклањање каменца: Over time, mineral deposits may accumulate in the hot water tank. Consult the manufacturer's website or customer support for recommended descaling procedures.
• Чишћење резервоара за воду: For thorough cleaning of the internal water tanks, it is recommended to contact a qualified service technician.

КСНУМКС. Решавање проблема

• Без додавања воде: Ensure the water bottle is properly seated and not empty. Check if the unit is plugged in and powered on.
• Без топле воде: Verify the hot water switch on the back of the unit is in the 'ON' position. Check if the thermal reset button (often a small red button on the back) needs to be pressed.
• No Cold Water: Ensure the unit is plugged in and the cold water thermostat is set to a desired temperature.
• цурење: Проверите да ли флаша за воду има пукотина или да ли је неправилно постављена. Уверите се да је посуда за капање правилно постављена.
• Необична бука: The unit is designed for quiet operation. If unusual or excessive noise occurs, ensure the unit is on a level surface and not vibrating against a wall. If noise persists, contact customer support.

7. Спецификације

• Модел: Б14А
• Димензије (Д к Ш к В): 12.3" x 12.7" x 37.9" (31.2 цм x 32.3 цм x 96.3 цм)
• Тежина: 32 фунти (14.5 кг)
• Боја: Black with Steel side panels
• Волtage: 110-120В
• учесталост: 50-60 Хз
• Температура топле воде: Approximately 185°F (85°C) (non-adjustable)
• Температура хладне воде: 35.6°F - 53.6°F (2°C - 12°C) (adjustable)
• Compatible Bottle Sizes: 5 галона (18.9 литара)
• Грађевински материјали: Нерђајући челик, пластика
• Сертификати: CE, NSF, UL, Energy Star Rated
• Посуда за капање: Concealed, lift-out design, high impact, durable ABS. Removable, anti-splash grid.

8. Гаранција и подршка

The Clover B14A Hot and Cold Bottled Water Dispenser comes with a Једногодишња ограничена гаранција произвођача. For warranty claims, technical assistance, or further inquiries, please contact Clover customer support. Keep your purchase receipt as proof of purchase.