Eldom 72324PMP 7-Liter Under-Sink Pressure-Resistant Water Heater User Manual

1. Безбедносна упутства

Please read these safety instructions carefully before installing, operating, or performing maintenance on the appliance. Failure to follow these instructions may result in electric shock, fire, property damage, or personal injury.

• Installation and electrical connections must be performed by qualified personnel in accordance with local regulations.
• Уверите се да је уређај правилно уземљен.
• Do not operate the water heater if the power cord or plug is damaged.
• Always ensure the water heater is filled with water before switching on the power.
• The pressure relief valve must be installed and maintained correctly to prevent excessive pressure build-up. Do not block or tampса вентилом.
• Држите запаљиве материјале даље од уређаја.
• Овај уређај је дизајниран само за унутрашњу употребу.

2. Производ је готовview

The Eldom 72324PMP is a compact 7-liter under-sink electric water heater designed for pressure-resistant operation. It features a durable steel tank with high-performance enamel and additional anode protection against corrosion, ensuring a long service life. An integrated anti-return valve prevents backflow and protects against overpressure. The continuous temperature regulator allows precise control over water temperature.

Figure 1: Eldom 72324PMP 7-Liter Under-Sink Water Heater. This image shows the compact design suitable for under-sink installation.

Кључне карактеристике:

• Капацитет: 7 литара
• Тип инсталације: Under-sink, pressure-resistant
• Материјал резервоара: Steel with high-performance enamel coating
• Заштита од корозије: Anode protection system
• безбедност: Integrated anti-return valve and safety valve
• Контрола температуре: Continuous temperature regulator
• Снага: 1500 В
• Енергетска ефикасност: Класа Б

3. Техничке спецификације

Figure 2: Energy Label for Eldom 72324PMP, indicating Class B efficiency and 95 kWh/annum consumption.

За детаљније информације о производу, погледајте базу података EPREL: https://eprel.ec.europa.eu/qr/85466

4. Подешавање

4.1 Постављање

• The water heater is designed for under-sink installation. Ensure there is sufficient space for the unit and its connections.
• Mount the unit securely to a solid surface, such as a wall, using appropriate fasteners. The unit is designed for wall mounting.
• Ensure the location is protected from freezing temperatures.

4.2 Прикључак за воду

Connect the water heater to the cold and hot water supply using 1/2 inch connections. It is crucial to install the supplied safety valve on the cold water inlet. This valve prevents excessive pressure build-up inside the tank.

1. Install the safety valve on the cold water inlet pipe. Ensure the arrow on the valve points towards the water heater.
2. Connect the cold water supply to the inlet of the safety valve.
3. Connect the hot water outlet of the water heater to the hot water tap.
4. Open the hot water tap to allow air to escape while the tank fills with water.
5. Once water flows steadily from the hot water tap, close the tap. Check all connections for leaks.

4.3 Електрични прикључак

The appliance comes with a power cable and plug. Ensure the electrical outlet is properly grounded and matches the voltage and frequency requirements (230V/50Hz).

• Before plugging in the appliance, ensure the water tank is completely filled.
• Укључите кабл за напајање у одговарајућу уземљену електричну утичницу.
• Немојте користити продужне каблове или адаптере.

5. Оперативни

5.1 Прво покретање

After installation and filling the tank with water, the unit is ready for operation.

1. Ensure the water heater is properly connected to both water and electricity.
2. Turn on the power supply to the unit. The indicator light (if present) should illuminate.
3. The water heater will begin heating the water to the set temperature. The initial heating cycle for 7 liters from 12°C to 65°C takes approximately 13 minutes.

5.2 Подешавање температуре

The water heater is equipped with a continuous temperature regulator, usually a dial or knob on the front or bottom of the unit.

• Rotate the temperature regulator to your desired setting. Higher settings will result in hotter water.
• Термостат ће аутоматски одржавати подешену температуру.

6. Одржавање

Regular maintenance ensures optimal performance and extends the lifespan of your water heater. Always disconnect the power supply before performing any maintenance.

6.1 Редовно чишћење

• Очистите спољашњост јединице меком, дamp тканина. Немојте користити абразивна средства за чишћење или раствараче.
• Periodically check the safety valve for proper operation. Refer to the safety valve manufacturer's instructions for testing.

6.2 Уклањање каменца

Depending on water hardness, scale deposits may accumulate inside the tank and on the heating element, reducing efficiency. Descaling should be performed periodically by a qualified technician.

• Disconnect the power supply and drain the water heater.
• Access the heating element and tank interior to remove scale deposits.
• Replace the anode rod if it is significantly depleted, as it is crucial for corrosion protection.

КСНУМКС. Решавање проблема

Пре него што контактирате корисничку подршку, проверите следеће уобичајене проблеме и решења:

8. Гаранција и подршка

This Eldom water heater is manufactured to high-quality standards. For warranty information, please refer to the documentation provided with your purchase or contact your retailer.

Контакт информације произвођача:

• Произвођач: Елдоминвест
• Webсајт: https://eldominvest.com/
• Емаил: tech@eldominvest.com
• Телефон: +359 52 571 914
• Адреса: Boulevard "Vladislav Varnenchik" 275A, 9009 Varna, Bulgaria