Geberit G243173001 Water Supply Hose

Увод

This manual provides essential instructions for the safe and correct installation, operation, and maintenance of the Geberit G243173001 Water Supply Hose. This hose is specifically designed to connect the water supply to the Geberit Duofix Carrier 111.798, which is used with bidet seats. Please read this manual thoroughly before installation and keep it for future reference.

Безбедносне информације

• Увек искључите главни довод воде пре почетка било каквих водоинсталатерских радова.
• Ensure all connections are hand-tightened first, then gently tightened with a wrench to prevent leaks without overtightening.
• Inspect the hose and connections regularly for any signs of wear, damage, or leaks.
• Ако нисте сигурни у вези са било којим кораком, консултујте квалификованог водоинсталатера.

Садржај пакета

The Geberit G243173001 package includes:

• 1 x Geberit G243173001 Water Supply Hose

No additional tools or components are included with this product.

Спецификације

Подешавање и инсталација

Before you begin, ensure the main water supply to the toilet area is turned off. You may need a wrench for tightening connections.

1. Припремите простор: Turn off the main water supply valve. Flush the toilet to drain the tank and bowl.
2. Идентификујте тачке повезивања: The Geberit G243173001 hose has two distinct ends. One end connects to the water supply valve, and the other connects to the Geberit Duofix Carrier 111.798.
3. Прикључите се на водовод: Carefully attach one end of the hose to the water supply valve. Hand-tighten first, then use a wrench for a quarter to half turn until snug. Do not overtighten.


Image: Water supply connection point of the hose.

4. Connect to Duofix Carrier: Attach the other end of the hose to the designated water inlet on the Geberit Duofix Carrier 111.798. Hand-tighten, then use a wrench for a snug fit.


Image: Carrier connection point of the hose.

5. Коначна провера: Уверите се да су обе везе безбедне.

Слика: Прекоview of the Geberit G243173001 Water Supply Hose.

Оперативни

After installation, slowly turn on the main water supply valve. Check all connections for leaks immediately. If no leaks are present, the system is ready for use with the Geberit Duofix Carrier and connected bidet seat.

Одржавање

• Periodically inspect the hose and its connections for any signs of wear, cracks, bulges, or corrosion.
• Check for any drips or moisture around the connection points. Address any leaks promptly.
• Replace the hose if any damage is observed to prevent potential water damage.

Решавање проблема

Цурења на прикључцима

• Узрок: Loose connection or damaged washer/gasket.
• решење: Turn off water supply. Gently tighten the connection with a wrench. If the leak persists, check the washer/gasket inside the connector for proper seating or damage. Replace if necessary.

Нема протока воде

• Узрок: Water supply valve is off or partially closed.
• решење: Ensure the main water supply valve and any inline shut-off valves are fully open.

Информације о гаранцији

For detailed warranty information regarding the Geberit G243173001 Water Supply Hose, please refer to the official Geberit website or contact Geberit customer service directly. Warranty terms and conditions may vary.

Корисничка подршка

If you have any questions, require technical assistance, or need to order replacement parts, please visit the official Geberit website or contact their customer support department. Contact details can typically be found on the Geberit webсајт или паковање производа.