PIZZELLO Caldo 43-Inch Propane Fire Pit Table Instruction Manual

1. Важне информације о безбедности

Read and understand all instructions and safety warnings before assembling, operating, or servicing this appliance. Failure to follow these instructions could result in fire, explosion, property damage, personal injury, or death.

• САМО ЗА ВАЊСКУ УПОТРЕБУ: Never operate this appliance indoors or in an enclosed area.
• УПОЗОРЕЊЕ У ВЕЗИ СА ПРОПАНОМ: This appliance uses propane gas. Ensure proper ventilation and never store propane cylinders indoors.
• ЧИСТОСТ ДО ЗАПАЉИВИХ МАТЕРИЈА: Maintain adequate clearance from combustible materials. Refer to local codes and regulations.
• CSA CERTIFIED: This PIZZELLO fire pit table is CSA certified, ensuring it meets high safety standards for propane fuel use.
• БЕЗБЕДНОСТ ДЕЦЕ: Keep children and pets away from the fire pit during operation and while it is cooling down. Never leave children unattended near the appliance.
• ТОПЛЕ ПОВРШИНЕ: The fire pit and surrounding surfaces will be hot during and after use. Allow sufficient time for cooling before touching.
• ТИП ГОРИВА: Use only Liquefied Petroleum Gas (LPG). Do not use natural gas or any other fuel.

2. Садржај пакета

Verify all components are present and undamaged before assembly. If any parts are missing or damaged, do not proceed with assembly and contact customer service.

• Fire Pit Table (43"x23"x24.8") x 1
• Glass Wind Guard (23.6"x9.3"x4") x 1
• Fire Glass Stones (8 LBS) x 1
• Заштитни поклопац x 1
• Removable Lid x 1

3. Подешавање и монтажа

Follow these steps for proper assembly. It is recommended to have two people for certain steps.

3.1. Видео водич за монтажу

For a visual guide, please refer to the official assembly video:

3.2. Монтажа корак по корак

1. Припремите базу: Lay the table top (part 6) upside down on a soft, clean surface to prevent scratches. Attach the side panels (parts 1 and 2) to the table top using the provided screws and washers.
2. Install Internal Supports: Connect the internal support bars (part 8) to the side panels (parts 1 and 2) using screws. These bars provide structural integrity.
3. Причврстите предњи панел: Secure the front panel (part 5) to the assembled structure. Ensure all connections are tight.
4. Install Propane Tank Tray: Attach the propane tank tray frame (part 4) to the base structure. This frame includes wheels for easy access to the propane tank.
5. Install Drawer Tracks: Stretch the glide tracks (part 9L and 9R) and attach them to the side panels and the propane tank tray frame. Ensure the tracks are correctly oriented (Left/Right).
6. Причврстите задњу плочу: Secure the rear panel (part 3) to complete the main body of the fire pit table.
7. Поставите ватрено стакло: Carefully pour the 8 LBS of fire glass stones (part 12) into the burner area. Distribute them evenly around the burner.
8. Install Wind Guard: Assemble the glass wind guard (part 13) according to its separate instructions and place it around the burner area.
9. Повежите резервоар за пропан: Slide out the tank storage tray. Connect a 20 lb propane tank (not included) to the gas line. Ensure all connections are secure and check for leaks using a soapy water solution.

4. Упутство за употребу

Follow these steps to safely ignite and operate your PIZZELLO fire pit table.

1. Пре паљења: Ensure the propane tank valve is fully open. Remove the removable lid from the burner area.
2. Електронско паљење: Push and turn the control knob to the 'LOW' position. While holding the knob, press the electronic ignitor button repeatedly until the burner lights.
3. Release Control Knob: Once the burner is lit, continue to hold the control knob for 15 seconds to allow the thermocouple to heat up. Release the knob; the burner should remain lit. If the burner does not light or goes out, wait 5 minutes and repeat the lighting procedure.
4. Подесите пламен: Rotate the control knob to adjust the flame height and heat output (up to 50,000 BTUs) to your desired level.
5. Да искључите: Turn the control knob to the 'OFF' position. Close the valve on the propane tank. Allow the unit to cool completely before covering or moving.

4.1. Converting to a Table

When not in use as a fire pit, the included removable lid allows you to convert the unit into a functional dining table, coffee table, or casual bar table.

5. Одржавање

Редовно одржавање осигурава дуготрајност и безбедан рад вашег стола за ватру.

• Чишћење: Clean the exterior surfaces with a soft cloth and mild soap solution. Avoid abrasive cleaners.
• Faux Stone Care: The faux stone surface is manufactured with specially formulated polyurethane, fire retardants, and UV inhibitors. Clean gently to maintain its visual appeal.
• Заштитни поклопац: Always use the provided waterproof protective cover when the fire pit is not in use and has cooled down. This protects it from weather elements.
• Одржавање горионика: Periodically inspect the burner and gas connections for any signs of damage or blockages. Keep the burner ports clear of debris.

КСНУМКС. Решавање проблема

If you encounter issues with your fire pit table, refer to the following common problems and solutions:

7. Спецификације

Detailed product specifications for your reference.

8. Гаранција и подршка

Your PIZZELLO fire pit table comes with a 12-month warranty from the date of purchase.

For any questions, concerns, or warranty claims, please contact our customer service team. We are committed to responding within 24 hours to assist you.

Контакт за корисничку подршку: Refer to your purchase documentation or the PIZZELLO official webсајт за контакт детаље.