HEIMAN WS-720ES Wi-Fi Carbon Monoxide Detector User Manual

Увод

This manual provides essential information for the proper installation, operation, and maintenance of your HEIMAN WS-720ES Wi-Fi Carbon Monoxide Detector. Please read it thoroughly before use and retain it for future reference.

Важне информације о безбедности

Carbon monoxide (CO) is a colorless, odorless, and tasteless gas that can be fatal. This detector is designed to alert you to the presence of CO gas. It is not a substitute for proper maintenance of fuel-burning appliances or adequate ventilation.

• Никада немојте занемарити аларм. Investigate the source of the CO.
• Не фарбајте детектор. Paint can clog the sensor openings and prevent the alarm from functioning properly.
• Do not block the detector's vents.

Производ је завршенview

The HEIMAN WS-720ES is a compact, portable Wi-Fi enabled carbon monoxide detector designed for various environments. It features a clear 85 dB alarm and LED indicators for status.

Инсталација

The detector can be installed on flat surfaces or walls. Choose a location where CO is likely to accumulate, such as near fuel-burning appliances, but not directly above them or in areas with high humidity or extreme temperatures.

1. Монтажа: Use the provided screws and wall plugs to secure the mounting plate to a wall or ceiling. Alternatively, the detector can be placed on a flat surface.
2. Инсталација батерије: Insert the two AA batteries into the battery compartment. Ensure correct polarity. The device will perform a self-test upon power-up.
3. Пласман: For optimal detection, place the detector at eye level (approximately 1.5 to 1.7 meters from the floor) in areas with potential CO sources. Avoid corners or areas obstructed by furniture.

Wi-Fi Connection and App Integration

This detector connects to your home Wi-Fi network (2.4 GHz) and integrates with the Tuya or Smartlife application for remote monitoring and notifications.

1. Преузми апликацију: Преузмите апликацију „Tuya Smart“ или „Smart Life“ из продавнице апликација на вашем паметном телефону.
2. Регистрација/Пријава: Направите налог или се пријавите на свој постојећи налог.
3. Додај уређај: In the app, select "Add Device" and follow the on-screen instructions to add the Carbon Monoxide Detector. You may need to press the test button three times consecutively to put the device into pairing mode.
4. Потврда: Once connected, the app will display the device status and allow you to receive real-time alerts and view CO concentration levels.

Upravljanje detektorom

ЛЕД индикатори:

• Green LED (Power): Flashes every 30 seconds, indicating normal operation.
• Red LED (Alarm): Flashes rapidly with an audible alarm when CO is detected.
• Yellow LED (Fault/Low Battery): Indicates a fault or low battery condition.

Тестирање детектора:

Press and hold the "Test/Silence" button for a few seconds. The alarm will sound, and the red LED will flash, indicating the unit is functioning correctly. A notification should also appear in your connected app.

Silencing an Alarm:

In case of a CO alarm, press the "Test/Silence" button to temporarily silence the audible alarm. The red LED will continue to flash until CO levels return to normal. If the alarm persists, evacuate the area immediately.

Одржавање

• Замена батерије: The detector uses 2 AA batteries with an estimated life of 5 years. When the yellow LED indicates low battery, replace both batteries with new ones.
• Чишћење: Regularly clean the detector's exterior with a soft, damp тканина. Немојте користити средства за чишћење или раствараче.
• Редовно тестирање: Test the detector weekly by pressing the "Test/Silence" button.

Решавање проблема

Спецификације

Гаранција и подршка

For warranty information and technical support, please refer to the documentation included with your purchase or visit the official HEIMAN webсајт. Сачувајте рачун као доказ о куповини.