KICKER 48TRTP122+CANDY-X1B+AMPКИТ4

KICKER 48TRTP122 Subwoofer and DS18 CANDY-X1B Ampлифиер Систем Усер Мануал

Model: 48TRTP122+CANDY-X1B+AMPКИТ4

1. Производ је готовview

This manual provides instructions for the KICKER 48TRTP122 12-inch CompRT Down-Firing Loaded Subwoofer Enclosure, the DS18 CANDY-X1B Mono Class D Amplifier, and the accompanying DS18 AMPKIT4 4AWG Complete Amplifier Wiring Kit. This system is designed to enhance your vehicle's audio experience with powerful bass output.

2. Шта је у кутији

  • Kicker 48TRTP122 12" CompRT Series Down-Firing Loaded Subwoofer Enclosure
  • DS18 CANDY-X1B Mono Candy-X Series Car Ampлифиер
  • ДС18 AMPKIT4 4AWG Complete Amplifier Kit, including:
    • 17 ft 4 AWG Red Power Wire
    • 3 ft 4 AWG Black Ground Wire
    • Даљински кабл од 17 стопа
    • 17 ft Red/Black Speaker Cable
    • 17 ft Red/Black Twisted RCA Cable
    • Mini ANL Fuse Holder with Mini ANL 100A Fuse
    • 6 ft 4 AWG Loom Tube
    • 1 x Rubber Grommet
    • 10 к везице за каблове
    • 2 к прстенасти терминали
    • 2 к Спаде терминала
    • 5 x Small Spade Terminals
Contents of the DS18 AMPKIT4 4AWG Complete Amplifier Kit, showing various wires, fuse holder, terminals, and cable ties.

Figure 2.1: Components of the DS18 AMPKIT4 4AWG Complete Ampлифиер Кит.

3. Подешавање и инсталација

Правилна инсталација је кључна за оптималне перформансе и безбедност. Ако нисте сигурни у вези са било којим корацима, консултујте професионалног инсталатера ауто аудио система.

3.1 Мере предострожности

  • Искључите негативни терминал акумулатора возила пре почетка било каквих електричних радова.
  • Уверите се да су све ожичење правилно изоловане и осигуране како бисте спречили кратки спојеви и оштећења.
  • Користите одговарајућу личну заштитну опрему (ЛЗО) током инсталације.

3.2 Subwoofer Enclosure Placement

The KICKER 48TRTP122 is a down-firing enclosure, designed to be placed in the trunk or cargo area of your vehicle. Ensure it is securely fastened to prevent movement during driving.

KICKER 48TRTP122 12-inch CompRT Down-Firing Loaded Subwoofer Enclosure, black carpeted finish.

Figure 3.1: KICKER 48TRTP122 Down-Firing Subwoofer Enclosure.

3.3 Ampлифиер Моунтинг

Mount the DS18 CANDY-X1B amplifier in a location that allows for adequate ventilation and protection from moisture. Common locations include under a seat, in the trunk, or on the back of a rear seat. Ensure it is securely mounted to prevent vibration damage.

DS18 CANDY-X1B Mono Class D Amplifier, black with red accents.

Figure 3.2: DS18 CANDY-X1B Mono Class D Ampлифиер.

3.4 Упутства за ожичење

Follow these steps carefully for wiring the system. Refer to the wiring diagram below for visual guidance.

  1. Power Wire (Red 4 AWG): Run the 17 ft red power wire from the vehicle's positive battery terminal to the fuse holder, then from the fuse holder to the +12V terminal on the DS18 amplifier. Ensure the fuse holder is installed close to the battery (within 18 inches).
  2. Ground Wire (Black 4 AWG): Connect the 3 ft black ground wire from the GND terminal on the ampПоставите пуњач на чисту, неофарбану металну површину на шасији возила. Обезбедите добру електричну везу.
  3. Кабл за даљинско укључивање: Connect the remote wire from your head unit's remote output to the REM terminal on the ampспасилац. Ова жица окреће ampукључивање и искључивање горионика помоћу ваше главне јединице.
  4. RCA каблови: Connect the RCA cables from your head unit's subwoofer output (or full-range output if no dedicated sub output) to the RCA input jacks on the DS18 ampлифиер.
  5. Жица звучника: Повежите кабл звучника са amplifier's speaker output terminals to the KICKER subwoofer enclosure's input terminals. Ensure correct polarity (+ to + and - to -). The KICKER 48TRTP122 enclosure has a 2-ohm impedance.
  6. бас даљински: Connect the included bass remote to the dedicated remote port on the DS18 amplifier. Mount the remote in an accessible location for easy adjustment.
Wiring diagram showing a 2-ohm subwoofer connected to a 2-ohm amplifier output, with positive and negative terminals clearly marked.

Figure 3.3: Subwoofer to Amplifier Wiring Diagram (2-ohm connection).

DS18 Bass Remote control unit with a rotary knob and connected cable.

Figure 3.4: DS18 Bass Remote Control.

4. Упутство за употребу

Once the system is installed, follow these steps to configure and operate your subwoofer and ampлифиер.

4.1 Почетно укључивање и подешавање појачања

  1. Поново спојите негативни терминал акумулатора возила.
  2. Укључите главну јединицу. amplifier should power on (indicated by a blue LED on the ampлифиер).
  3. Подесите amplifier's GAIN control to its minimum (fully counter-clockwise) position.
  4. Play a music track with strong bass at a moderate volume level on your head unit (around 75% of maximum volume).
  5. Полако повећавајте контролу GAIN на amplifier until you hear distortion, then back it off slightly until the sound is clear. This sets the maximum clean output level.

4.2 Amplifier Controls (DS18 CANDY-X1B)

The DS18 CANDY-X1B amplifier features several controls for fine-tuning your bass output:

  • ДОБИТАК: Adjusts the input sensitivity to match the output of your head unit. (See 4.1)
  • BASS BOOST (0-18 dB): Increases the bass output at a specific frequency (typically around 45 Hz). Use sparingly to avoid distortion and speaker damage.
  • LPF (Low-Pass Filter) (50-150 Hz): This filter allows only frequencies below the set point to pass through to the subwoofer. Adjust to blend the subwoofer's output seamlessly with your main speakers.
  • SUBSONIC FILTER (10-55 Hz): Filters out extremely low frequencies that are inaudible and can cause damage to the subwoofer. Set it slightly below your subwoofer's lowest usable frequency.
  • PHASE (0/180 degrees): Подешава фазу излаза сабвуфера у односу на главне звучнике. Експериментишите са оба подешавања да бисте пронашли оно које пружа најснажнији и најкохерентнији бас.
  • ДАЉИНСКИ: Port for connecting the wired bass remote control, allowing convenient bass level adjustment from the driver's seat.
Close-up of the DS18 CANDY-X1B amplifier's control panel, showing gain, bass boost, LPF, subsonic filter, and phase controls.

Figure 4.1: DS18 CANDY-X1B Amplifier Controls.

5. Одржавање

Regular maintenance ensures the longevity and optimal performance of your audio system.

  • Чишћење: Држите кућиште сабвуфера и amplifier clean and free of dust and debris. Use a soft, dry cloth. Avoid liquid cleaners directly on components.
  • Везе: Периодично проверавајте све спојеве ожичења да ли су чврсти и да ли постоји корозија. Лабави спојеви могу довести до лошег рада или оштећења.
  • вентилација: Осигурајте amplifier's cooling fins are not obstructed to prevent overheating.
  • Провера осигурача: Ако је amplifier does not power on, check the fuse in the fuse holder near the battery. Replace with a fuse of the same rating (100A Mini ANL).

КСНУМКС. Решавање проблема

Погледајте овај одељак за уобичајене проблеме и њихова решења.

ПроблемМогући узрокРешење
Нема звука из сабвуфера
  • Нема снаге да ampлифиер
  • Лабави RCA или звучнички прикључци
  • Подешавања главне јединице
  • Amplifier in protection mode
  • Check power, ground, and remote wires. Verify fuse.
  • Ensure all RCA and speaker wires are securely connected.
  • Check head unit's subwoofer output settings and volume.
  • Искључите и поново покрените amplifier. Check for shorts in speaker wiring.
Изобличен звук
  • Појачање је подешено превисоко
  • Bass boost too high
  • Исечак са главне јединице
  • Оштећена жица звучника
  • Смањите ampлифиер добитак.
  • Lower bass boost setting.
  • Reduce head unit volume.
  • Inspect speaker wires for damage or shorts.
Ampлифиер се прегрева
  • Недовољна вентилација
  • Неправилно импедансно оптерећење
  • Појачање је подешено превисоко
  • Осигурати ampУпијач има чист проток ваздуха.
  • Проверите подударање импедансе сабвуфера amplifier's stable load (2 ohms for this system).
  • Смањите ampлифиер добитак.
Bass remote not working
  • Лабава веза
  • Оштећен кабл
  • Check the connection of the remote cable to the ampлифиер.
  • Прегледајте кабл за видљива оштећења.

7. Спецификације

Detailed specifications for the components in this bundle.

7.1 KICKER 48TRTP122 12" CompRT Subwoofer Enclosure

  • Тип звучника: Субвоофер
  • Пречник сабвуфера: 12 инча
  • Максимална снага: 1000 вати
  • РМС снага: 500 вати
  • импеданса: 2 ома
  • Осетљивост: 98дБ
  • Посебна карактеристика: Down-Firing, Active thin-mount CompRT subwoofer, High-output reFLEX passive woofer
  • Материјал: Влакнасте плоче средње густине
  • Димензије: 27.5" W x 6.125" H x 14.625" D (Top) x 14.625" D (Bottom)

7.2 DS18 CANDY-X1B Mono Class D Ampлифиер

  • РМС снага:
    • 4 ohms: 240 watts x 1 channel
    • 2 ohms: 400 watts x 1 channel
    • 1 ohm: 600 watts x 1 channel
  • Максимална излазна снага: 1800 вати
  • Осетљивост: 100дБ
  • Фреквенцијски одзив: 20-150 Хз
  • бас даљински: Укључено
  • Дизајн: Класа Д
  • Променљиво појачање баса: 0-18 дБ
  • Variable Low-pass filter (LPF): 50-150 Хз
  • Подзвучни филтер: 10-55 Хз
  • Димензије: 5.9 cm Š x 8.3 cm D x 2.16 cm V

7.3 ДС18 AMPKIT4 4AWG Complete Ampлифиер Кит

  • Калибар жица: 4 АВГ
  • Материјал жице: High Performance CCA (Copper Clad Aluminum)
  • Препоручује се за: Један amplifier up to 1300 Watts
  • Укључене компоненте: Power wire, ground wire, remote wire, speaker cable, RCA cable, fuse holder with 100A fuse, loom tube, grommet, cable ties, various terminals.

8. Информације о гаранцији

This product bundle typically comes with a manufacturer's warranty. The KICKER 48TRTP122 subwoofer enclosure and DS18 CANDY-X1B amplifier are covered by a full warranty from their respective manufacturers. Specific warranty terms, duration, and coverage details may vary. Please retain your proof of purchase for warranty claims.

For detailed warranty information, refer to the documentation included with each individual component or visit the respective manufacturer's official webсајту.

9. Подршка

If you encounter issues not covered in this manual or require further assistance, please contact the manufacturer's customer support:

  • KICKER Support: Посетите званични KICKER webсајт за ресурсе подршке, честа питања и контакт информације.
  • DS18 Support: Посетите званични DS18 website for product support and contact details.

When contacting support, please have your product model numbers (48TRTP122, CANDY-X1B, AMPKIT4) and proof of purchase readily available.