addlon 80-inch 3 Wood Blades Ceiling Fan with Light

Важна безбедносна упутства

Пажљиво прочитајте сва упутства пре почетка инсталације. Непоштовање ових упутстава може довести до струјног удара, пожара или телесних повреда.

• УПОЗОРЕЊЕ: Да бисте смањили ризик од струјног удара, уверите се да је струја искључена на прекидачу или кутији са осигурачима пре почетка.
• Све ожичење мора бити у складу са националним и локалним електричним прописима. Ако нисте упознати са ожичењем, консултујте квалификованог електричара.
• The fan must be mounted with a minimum of 7 feet (2.1 meters) clearance from the floor to the trailing edge of the blades.
• Ensure the outlet box is securely attached to the building structure and can support the fan's weight (at least 35 lbs / 15.9 kg).
• Не користите вентилатор са оштећеним лопатицама. Замените све лопатице ако је једна оштећена.
• Не убацујте предмете у путању лопатица вентилатора.

Садржај пакета

Carefully unpack your fan and inspect the contents. You should have the following items:

• Склоп кућишта мотора
• Лопатице вентилатора (3)
• Бладе Брацкетс
• Довнрод Ассембли
• Носач
• Склоп светлосног комплета
• Даљински управљач са зидним носачем
• Пакет хардвера (шрафови, подлошке, навртке)
• Упутство за употребу

Figure 1: addlon 80-inch 3 Wood Blades Ceiling Fan with Light. This image shows the complete fan assembly, including the motor housing, three wood blades, and the integrated light kit.

Подешавање и инсталација

Follow these steps to properly install your addlon ceiling fan. Ensure power is OFF at the circuit breaker before proceeding.

1. Инсталација носача за монтажу: Secure the mounting bracket to the ceiling outlet box using the screws provided. Ensure the bracket is firmly attached to a structural beam or a fan-rated outlet box.
2. Склоп Довнрода: Insert the downrod through the canopy and coupling cover. Feed the motor wires through the downrod. Secure the downrod to the motor housing with the provided pin and screws.
3. Висећи вентилатор: Carefully lift the fan assembly and place the downrod ball into the mounting bracket opening. Ensure the tab on the mounting bracket aligns with the slot on the downrod ball.
4. Електричне везе: Connect the fan's electrical wires to the house wiring according to the wiring diagram in this manual (typically black to black, white to white, and green/bare copper to ground). Use the provided wire nuts and ensure all connections are secure.
5. Додатак за сечиво: Attach each fan blade to its blade bracket using the screws provided. Then, attach the blade brackets to the motor housing. Ensure all screws are tightened securely.
6. Инсталација комплета светла: Connect the light kit wires to the fan motor wires (usually blue to blue, white to white). Secure the light kit assembly to the bottom of the fan motor housing. Install the light cover.
7. Упаривање даљинског управљача: Once installation is complete and power is restored, follow the remote control pairing instructions provided in the remote control section to synchronize the remote with your fan.

Упутство за употребу

Your addlon ceiling fan is operated by the included remote control. Ensure the remote has fresh batteries installed (2x AAA, not included).

• Вентилатор УКЉУЧЕНО/ИСКЉУЧЕНО: Притисните тастер ФАН ОН/ОФФ дугме за укључивање или искључивање вентилатора.
• Контрола брзине вентилатора: Користите СПЕЕД buttons (usually marked with fan icons or numbers) to cycle through different fan speeds (e.g., Low, Medium, High).
• Светло укључено/искључено: Притисните тастер ЛИГХТ ОН/ОФФ дугме за укључивање или искључивање светла.
• Затамњивање светла: If your light kit supports dimming, press and hold the ЛИГХТ button to adjust the brightness. Release when the desired brightness is reached.
• Реверзна функција: Притисните тастер РЕВЕРСЕ button to change the direction of the fan blades. This is useful for seasonal comfort (downward airflow for cooling in summer, upward airflow for circulating warm air in winter). Allow the fan to stop completely before reversing direction.
• Функција тајмера: Some models include a timer function. Press the ТИМЕР button (e.g., 1H, 2H, 4H) to set the fan to turn off automatically after a set period.

Note: The remote control may need to be paired with the fan upon initial setup or after power outages. Refer to the remote control's specific instructions for pairing procedures.

Одржавање

Regular maintenance ensures the longevity and optimal performance of your addlon ceiling fan. Always turn off power at the circuit breaker before performing any maintenance.

• Чишћење: Користите меку, дamp крпу за чишћење лопатица вентилатора и кућишта мотора. Не користите абразивна средства за чишћење или раствараче, јер могу оштетити завршну обраду.
• Нега сечива: Periodically check the blade screws for tightness. Loose screws can cause wobbling and noise.
• Замена сијалице: If the light bulb needs replacement, ensure the power is off. Allow the bulb to cool before removing. Replace with a bulb of the same type and wattage as specified in the light kit instructions.
• Годишња провера: Annually, check all connections and screws for tightness. There is no need to lubricate the fan motor as it has permanently lubricated bearings.

Решавање проблема

Before contacting customer support, try these troubleshooting steps for common issues:

Спецификације

Гаранција и корисничка подршка

addlon products are manufactured to the highest quality standards and are warranted against defects in materials and workmanship. Please refer to the warranty card included with your purchase for specific terms and conditions.

For technical assistance, replacement parts, or general inquiries, please contact addlon customer support:

• Webсајт: addlon Official Store on Amazon
• Емаил: support@addlon.com (placeholder email, as none provided)
• Телефон: 1-800-XXX-XXXX (placeholder phone, as none provided)

Please have your model number (80-inch 3 Wood Blades Ceiling Fan with Light) and purchase date available when contacting support.