Kidde детектор дима и угљен-моноксида 30CUDR-V - упутство за употребу

1. Увод

This manual provides essential information for the installation, operation, and maintenance of your Kidde 30CUDR-V Smoke and Carbon Monoxide (CO) Detector. This device is designed to alert you to the presence of both smoke and carbon monoxide hazards in your home. Please read this manual thoroughly before installation and retain it for future reference.

Image: Two Kidde 30CUDR-V combination smoke and carbon monoxide detectors, shown with their packaging.

2. Важне информације о безбедности

УПОЗОРЕЊЕ: This unit is designed to detect smoke and carbon monoxide. It is not designed to detect natural gas (methane), propane, butane, or other combustible fuels. This alarm is not a substitute for property, disability, life, or other insurance. Consult your insurance agent.

ОПАСНОСТ: Carbon Monoxide is an odorless, colorless, poisonous gas. If the alarm sounds, immediately move to fresh air and call emergency services.

ВАЖНО: Regular testing and maintenance are crucial for proper operation. Refer to the "Maintenance" section for details.

3. Садржај пакета

• Kidde 30CUDR-V Smoke and Carbon Monoxide Detector
• Монтажни прибор (вијци и анкери)
• 2 AA Alkaline Batteries (pre-installed or included separately)
• Упутство за употребу (овај документ)

4. Подешавање и инсталација

4.1 Инсталација батерије

The Kidde 30CUDR-V detector operates on two AA alkaline batteries. These batteries are typically included and may be pre-installed with a pull tab to activate. If not pre-installed, insert the batteries according to the polarity markings inside the battery compartment.

Image: The rear of the detector showing the battery compartment with two AA batteries correctly installed.

4.2 Место монтирања

For optimal performance and safety, follow these guidelines for mounting your detector:

• Install at least one detector on every level of your home, including basements and attics.
• For best smoke detection, install detectors in all sleeping areas and in the hallway outside of each separate sleeping area.
• For best CO detection, install detectors near sleeping areas and on every level of the home.
• Avoid placing detectors within 6 feet of fuel-burning appliances.
• Do not install in kitchens, garages, or furnace rooms where combustion particles are normally present, as this can lead to nuisance alarms.
• Avoid dead air spaces, such as the peak of an A-frame ceiling or in corners where walls and ceilings meet.

Image: A diagram illustrating recommended locations for various safety devices, including smoke and carbon monoxide alarms, within a typical home layout.

4.3 Монтажа детектора

The detector comes with a twist-and-click mounting bracket for easy installation.

1. Choose a suitable mounting location on a ceiling or wall.
2. Use the mounting bracket as a template to mark the screw holes.
3. Drill pilot holes and insert the plastic anchors if mounting into drywall or plaster.
4. Secure the mounting bracket to the ceiling or wall using the provided screws.
5. Align the detector with the mounting bracket and twist clockwise until it clicks securely into place.

Image: A person on a ladder installing the Kidde detector onto a ceiling, demonstrating the simple twist-and-click mounting process.

Слика: Детаљна view of the detector and its mounting bracket, highlighting the 5-inch diameter and other dimensions for installation planning.

5. Упутство за употребу

5.1 Почетно укључивање

Once batteries are installed and the unit is mounted, the detector will perform a self-test and enter normal operation mode. The green LED will flash periodically.

5.2 Тестирање аларма

Test the alarm weekly to ensure proper operation. Press and hold the Test/Hush button on the front of the detector until the alarm sounds. The alarm will emit a series of beeps and voice announcements. Release the button once the test sequence begins.

Image: A family in a living room, with the detector visible on the ceiling, representing the device's self-testing capability in a home environment.

5.3 Функција тишине

The Hush feature temporarily silences the alarm for approximately 7-10 minutes in case of a nuisance alarm (e.g., from cooking smoke). To activate, press the Test/Hush button during an alarm. The alarm will chirp every 30-40 seconds during the hush period. If smoke or CO levels are still present after the hush period, the alarm will reactivate.

Image: A toaster producing smoke from burnt toast, with the detector on the ceiling, illustrating the detector's ability to reduce nuisance alarms from common cooking activities.

6. LED Indicators and Voice Alerts

The Kidde 30CUDR-V uses both LED lights and voice announcements to communicate its status.

6.1 ЛЕД обавештења

• Зелена ЛЕД: Flashes every 60 seconds during normal operation.
• Амбер ЛЕД: Indicates a fault or error. Refer to the troubleshooting section.
• Црвена ЛЕД: Flashes rapidly during a smoke or CO alarm.

Image: A visual representation of the detector's LED indicators: Red for smoke/CO detection, Amber for fault/error, and Green for normal operation.

6.2 Гласовна упозорења

The detector provides clear voice announcements to specify the detected hazard:

• If smoke is detected, the alarm will announce: "Fire! Fire!"
• If carbon monoxide is detected, the alarm will announce: "Warning Carbon Monoxide!"
• Other alerts may include: "Replace Alarm" or "Low Battery".

Image: A graphic illustrating the distinct voice alerts provided by the detector for fire, carbon monoxide, and replacement notifications.

Image: The detector shown with visual cues of carbon monoxide detection, emphasizing its dual detection capability.

7. Одржавање

7.1 Замена батерије

The detector requires two AA alkaline batteries. Replace batteries at least once every 6 months, or immediately when the detector chirps and announces "Low Battery".

7.2 Чишћење детектора

Clean your detector at least once a month. Use a soft brush or vacuum cleaner with a soft brush attachment to remove dust and debris from the vents. Do not use cleaning solvents or spray cleaners directly on the unit.

7.3 Функција самотестирања

The detector includes a self-testing feature that continuously monitors its internal components. While this ensures the alarm is operating as expected, it is not a substitute for a manual push test. Perform a button test once per week to verify alarm operation.

КСНУМКС. Решавање проблема

9. Спецификације

• Модел: 30ЦУДР-В
• Извор напајања: 2 AA алкалне батерије (укључене)
• Тип сензора: Фотоелектрични (дим), електрохемијски (угљен-моноксид)
• Јачина звука аларма: 85 decibels at 10 feet
• Радна температура: 40°Ф (4.4°Ц) до 100°Ф (37.8°Ц)
• Радна влажност: 10-95% релативне влажности, без кондензације
• Димензије: 5" Diameter x 1.88" Depth (approximate)
• Сертификати: Meets UL 217 9th Edition, UL 2034 4th Edition, and FCC standards.

Image: The detector displaying its compliance with UL 217 and UL 2034 safety standards.

10. Гаранција и подршка

10.1 Ограничена гаранција

This Kidde detector comes with a 10-годишња ограничена гаранција. The warranty period begins when the alarm is powered on. If the power-on date is unknown, it is recommended to assume the alarm should be replaced after 10 years from the manufacturing date.

Image: A family in a kitchen setting, with the detector visible on the ceiling, accompanied by a graphic indicating a 10-year limited warranty.

10.2 Корисничка подршка

For technical assistance or warranty claims, please contact Kidde Customer Service. Refer to the contact information provided in the product packaging or visit the official Kidde webсајту.

Произвођач: Кидде

Број дела: 21032833

УПЦ: 047871328338

11. Додатне информације

11.1 State and Local Requirements

Always check your local building codes and regulations regarding smoke and carbon monoxide alarm installation. Requirements may vary by state and municipality.

Image: A map of the United States indicating various state and city requirements for carbon monoxide and smoke alarms, current as of December 2023.