SkyTech 3301P Programmable Fireplace Remote Control User Manual

1. Увод

The SkyTech 3301P remote control system is designed to provide a safe, reliable, and user-friendly remote control solution for gas heating appliances. This system allows for both thermostatic and manual operation from the transmitter. It can be easily programmed to custom settings and operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system utilizes one of 1,048,576 security codes, pre-programmed at the factory, which must be matched between the transmitter and receiver prior to initial use.

2. Безбедносне информације

Please read and understand all instructions before installing or operating this remote control system. Failure to follow these instructions may result in property damage, personal injury, or death. This system is intended for use with gas heating appliances only. Ensure all wiring is performed by a qualified professional if you are unsure. Always turn off the gas supply to the appliance before performing any installation or maintenance.

• Do not expose the remote control or receiver to water or excessive humidity.
• Држите батерије ван домашаја деце.
• Замените све батерије у исто време; немојте мешати старе и нове батерије.
• Истрошене батерије одложите на одговарајући начин у складу са локалним прописима.
• Ensure the fireplace appliance is in good working order before using the remote control system.

3. Package Contents and Components Overview

3.1 Садржај пакета

• Предајник (даљински управљач)
• Пријемник
• Валл Холдер
• Зидна плоча
• Упутство за инсталацију
• Batteries (4 AA batteries included)

3.2 Компоненте прекоview

The SkyTech 3301P system consists of a handheld transmitter and a receiver unit.

Предајник (даљински управљач)

• Дугмад: Features 8 buttons including Up/Mode/Down, Timer/Set/Prog/Ahead/Back, located below a flip cover.
• ЛЦД екран: Shows room temperature, thermostat set temperature, a 24-hour clock, and a 9-hour countdown timer.

Рецеивер Унит

The receiver unit is battery-powered and includes a learn function button and an On/Remote/Off slider switch.

4. Подешавање и инсталација

4.1 Инсталација батерије

Install the required batteries into both the transmitter and receiver units. Ensure correct polarity.

• предајник: Refer to the transmitter's battery compartment for specific battery type and orientation.
• Пријемник: Open the battery compartment on the receiver unit and insert the batteries as indicated.

4.2 Receiver Placement and Wiring

The receiver can be installed in a wall, on the hearth, or under the fireplace behind the control access panel. Ensure the location allows for proper signal reception and is protected from excessive heat or moisture.

1. Turn off the gas supply to the fireplace appliance.
2. Access the control panel of your fireplace.
3. Connect the wires from the receiver to the appropriate terminals on your fireplace's gas valve or control module. Typically, these are the TH (Thermostat) and TH/TP (Thermopile) terminals. Consult your fireplace appliance manual for specific wiring diagrams.
4. Secure the receiver in its chosen location.

4.3 Pairing the Transmitter and Receiver (Learning Function)

The transmitter and receiver are factory-paired, but if pairing is lost or a new component is introduced, follow these steps:

1. Ensure the receiver's slider switch is in the РЕМОТЕ положај.
2. Притисните и држите ЛЕАРН button on the receiver unit (refer to Image 1 for location) until you hear a beep or see an indicator light flash.
3. Within 10 seconds, press any button on the transmitter.
4. The receiver will emit a series of beeps or flashes to confirm successful pairing.

5. Операција

The SkyTech 3301P offers both manual and thermostatic control modes.

5.1 Receiver Slider Switch Modes

• НА: The fireplace will remain continuously on, bypassing remote control.
• ДАЉИНСКИ: The fireplace is controlled by the transmitter.
• ВАН: The fireplace will remain continuously off, bypassing remote control.

5.2 Функције предајника

Open the flip cover on the transmitter to access all control buttons.

• НАЧИН: Toggles between manual ON/OFF, thermostatic mode, and timer mode.
• Стрелице горе/доле: Adjust temperature settings, time, or program values.
• ТАЈМЕР: Activates the 9-hour countdown timer.
• КОМПЛЕТ: Used to confirm settings during programming.
• ПРОГ: Accesses programming functions for daily schedules.
• AHEAD/BACK: Navigates through programming periods.

5.3 Setting the Clock and Temperature

1. Притисните тастер СЕТ дугме за улазак у режим подешавања времена.
2. Користите ГОРЕ/ДОЉЕ arrows to adjust the hour and minute.
3. Притисните СЕТ again to confirm each setting.
4. To set the desired temperature in thermostatic mode, press the МОДЕ button until the thermostat icon appears.
5. Користите ГОРЕ/ДОЉЕ arrows to set your desired room temperature.

5.4 Programming the Thermostat

The 3301P allows for programmable heat periods. Refer to the detailed instructions in the included manual for specific programming steps for each day of the week.

6. Одржавање

6.1 Замена батерије

When the battery indicator on the transmitter's LCD display shows low power, or if the remote's range decreases, replace the batteries in both the transmitter and receiver. Always replace all batteries at the same time with new ones of the same type.

• предајник: Typically uses AAA batteries.
• Пријемник: Uses 4 AA batteries (included).

Напомена: If the batteries are removed for an extended period, you may need to re-pair the transmitter and receiver.

6.2 Чишћење

Wipe the remote control and receiver with a soft, dry cloth. Do not use abrasive cleaners or immerse in water.

КСНУМКС. Решавање проблема

8. Спецификације

9. Гаранција и подршка

For specific warranty information, please refer to the documentation included with your purchase or contact SkyTech customer support. Keep your proof of purchase for warranty claims.

If you encounter any issues not covered in this manual or require further assistance, please contact SkyTech customer service. Contact details are typically found on the product packaging or the manufacturer's official webсајту.