Кориснички приручник за Cisco PIM Cellular Pluggable Interface Module

Cisco PIM Cellular Pluggable Interface Module

Спецификације

• Подржава могућности закључавања и откључавања СИМ картице
• Подршка за две СИМ картице за потребе резервне копије
• Аутоматска активација СИМ картице за одговарајући фирмвер
• Избор јавне копнене мобилне мреже (PLMN)
• Подршка за приватне ЛТЕ и приватне 5Г мреже
• Два активна PDN професионалцаfileс на мобилном интерфејсу
• Подршка за IPv6 саобраћај података
• Функције мобилне услуге на Cisco IOS-XE

Предуслови за конфигурисање мобилног PIM-а

Напомена

You must have the appropriate antennas and antenna accessories to complete your installation. Consult the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for suggestions on possible solutions.

• If the signal is not good at the router, place the antenna away from router in a better coverage area. Please refer to the RSSI/SNR values as displayed through show cellular <x/x/x> all or the LED of the pluggable modem.
• You must have cellular network coverage where your router is physically placed. For a complete list of supported carriers.
• You must subscribe to a service plan with a wireless service provider and obtain a Subscriber Identity Module (SIM) card. Only micro SIMs are supported.
• You must install the SIM card before configuring the Cellular PIM or router.
• The standalone antenna that supports GPS capabilities must be installed for the GPS feature to work when available on the PIM.

Ограничења за конфигурисање мобилног PIM-а

• Currently, cellular networks support only user initiated bearer establishment.
• Due to the shared nature of wireless communications, the experienced throughput varies depending on the radio network capabilities, number of active users or congestion in a given network.
• Cellular bandwidth is asymmetric with the downlink data rate being greater than the uplink data rate, while on private cellular with TDD frequency band(s), it may be symmetrical.
• Cellular networks have higher latency compared to wired networks. Radio latency rates depend on the technology and carrier. Latency also depends on the signal conditions and can be higher because ofnetwork congestion.
• CDMA-EVDO, CDMA-1xRTT, and GPRS technology modes are not supported. 2G is only supported on the P-LTE-GB.
• Any restrictions that are part of the terms of service from your carrier.
• SMS—Only one text message up to 160 characters to one recipient at a time is supported. Larger texts are automatically truncated to the proper size before being sent.

Функције нису подржане

The following features are not supported:

• On Cisco IOS-XE, TTY support or Line is not available on cellular interface as it was on IOS classic.
• On Cisco IOS-XE, explicit Chat script /Dialer string doesn’t need to be configured for the cellular interface as it was on IOS classic.
• DM log output to USB flash is not supported
• Гласовне услуге

Главне карактеристике мобилног ПИМ-а

The PIM supports the following major features:

ФАК

• П: Могу ли да користим било коју врсту антена са Cisco Cellular Pluggable Interface Module?
  • A: No, it is recommended to use antennas and accessories specified in the Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide for compatibility and performance.
• П: Колико PDN професионалацаfileДа ли могу бити активни на мобилном интерфејсу?
  • A: До два PDN profiles can be active on the Cellular interface, depending on the SIM subscription and services.