Dickson WiZARD2 Replaceable Sensor Logger

Спецификације

Важно обавештење
Please follow the steps below before using your chart recorder for the first time.

Set Chart

1. Двапут притисните МЕНУ.
2. Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
3. Притисните МЕНУ да сачувате.
4. Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
5. Притисните МЕНУ да сачувате.

Подесите време

1. Притисните МЕНУ.
2. ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
3. Притисните МЕНУ да сачувате.
4. Press HOME. Pens will move onto the chart to begin recording.

Операција

За почетак рада

1. Remove the protective pen cap.
2. Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
3. Insert Batteries (4 C type) and plug into AC adapter.
4. Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
5. Press the power button and follow the display prompts to configure. Напомена: Unit may power on automatically when AC and battery power are applied.

ФАКс

What should I do if the unit does not power on?\

Ensure that both the AC adapter is plugged in and the batteries are correctly installed.

Документи / Ресурси

Dickson WiZARD2 Replaceable Sensor Logger [пдф] Упутство за кориснике WiZARD2 Replaceable Sensor Logger, WiZARD2, Replaceable Sensor Logger, Sensor Logger, Logger

Референце

• Упутство за употребу